A Parang - Part 1

This article A Parang - Part 1 is one of the articles you were looking for? If true, you are very right here. OK here's the information on the article A Parang - Part 1.

If you’re looking for top recommended Product of the day, then A Parang - Part 1 is our suggestion. Many good reviews already proving the quality of this product. The A Parang - Part 1 completed with a lot of capabilities which makes it great product. If you wish to know further of this Product, just read its main features below.

A Parang - Part 1

These are a couple of Malaysian parangs in the style popularised by Ray Mears.

I was asked to put  a handle on one the same as the large one shown.

The tangs are extremely short. While I don't mind a short stick tang on smaller knives, I think something longer is required on a chopper. I did suggest in this instance that I could weld an extension to the tang but the request was to make it a full tang.

 So a bit of a jump forward after a bit of cutting and welding of a piece of mild steel....

and then grinding it back so the curve at the rear is in the right place.

 

Compared against the new owners hand (quite a size difference between the two of us!)

I then fit some pieces of Laburnum that I've had seasoning for a number of years, with a spacer of micarta to extend the curve at the back down. I had left lots of material to reduce down later.

 and then, disaster!

Back to it after Christmas I did some rough shaping down...

but then flipping it over, gaps have appeared. It was glued solid and tight before - I believe that my very cold garage has caused pieces to move.

Extremely frustating but those scales have now been boiled off ready for new ones.

Laburnum soup!

Thank you for reading the article A Parang - Part 1.We sincerely hope you can understand that our article A Parang - Part 1 is taken from various sources. If the article useful A Parang - Part 1 don't forget to share. Thank You.